Replacing The Drive Module Main Fans (Frames R6 To R8) - ABB ACS580-07 Hardware Manual

122 Maintenance
￭

Replacing the drive module main fans (frames R6 to R8)

WARNING!
Obey the instructions in chapter
death, or damage to the equipment can occur.
1. Stop the drive and do the steps in section
you start the work.
2. Open the cabinet door.
3. Remove the drive module from the cabinet as described in section
module (frames R6 to R9) (page
4. Remove the two mounting screws of the fan mounting plate at the bottom of the drive
module.
5. Unplug the fan power supply wires from the drive.
6. Pull the fan mounting plate down from the side edge.
7. Unplug the fan power supply wires from the drive.
8. Lift the fan mounting plate off.
9. Remove the fan from the mounting plate.
Safety instructions. If you ignore them, injury or
Electrical safety precautions (page 16)
126).
a
6
Replacing the drive
4
b
3
before