Cmod-01 Multifunction Extension Module (External 24 V Ac/Dc And Digital I/O); Hardware Description; Product Overview; Layout - ABB ACS580-07 Hardware Manual

CMOD-01 multifunction extension module (external
24 V AC/DC and digital I/O)
￭

Hardware description

Product overview

The CMOD-01 multifunction extension module (external 24 V AC/DC and digital I/O) expands
the outputs of the drive control unit. It has two relay outputs and one transistor output, which
can function as a digital or frequency output.
In addition, the extension module has an external power supply interface, which can be
used to power up the drive control unit in case the drive power supply fails. If you do not
need the back-up power supply, you do not have to connect it because the module is
powered from the drive control board by default.
Note:
In frames R6...R9, you do not need a CMOD-01 module to use external 24 V AC/DC supply.
The external supply is connected directly to terminals 40 and 41 on the control unit.
WARNING!
Do not connect the +24 V AC cable to the control unit ground when the control
unit is powered using an external 24 V AC supply.

Layout

5
4
1 Grounding screw
2 Hole for mounting screw
3 3-pin terminal blocks for relay outputs
1
Optional I/O extension modules 241
6
2
Mechanical installation (page 242)
Mechanical installation (page 242)
Terminal designations (page 242)
3
3