Rcm Marking; Eac (Eurasian Conformity) Marking; China Rohs Marking - ABB ACS580-07 Hardware Manual

in this chapter. The ampere rating is based on tests done according to the appropriate
UL standard.
• The cables located within the motor circuit must be rated for at least 75 °C (167 °F) in
UL-compliant installations.
• The input cable must be protected with fuses. Suitable IEC and UL classified fuses are
listed elsewhere in this chapter. These fuses provide branch circuit protection in
accordance with the National Electrical Code (NEC) and Canadian Electrical Code. For
installation in the United States, also obey any other applicable local codes. For
installation in Canada, also obey any applicable provincial codes.
Note:
Circuit breakers must not be used without fuses in the USA. See chapter Ordering
information for suitable circuit breakers.
• The drive is equipped with UL classified fuses which provide branch circuit protection
in accordance with the National Electrical Code (NEC) and Canadian Electrical Code.
The fuses are listed elsewhere in this chapter.
• The drive provides motor overload protection. For adjustments, see the firmware manual.
• For drive overvoltage category, see

RCM marking

RCM marking is required in Australia and New Zealand. An RCM mark is attached to each
drive in order to verify compliance with the relevant standard (IEC 61800-3:2004), mandated
by the Trans-Tasman Electromagnetic Compatibility Scheme.
For fulfilling the requirements of the standard, see section Compliance with EN 61800-3:2004.

EAC (Eurasian Conformity) marking

The drive has EAC certification. EAC marking is required in Russia, Belarus and Kazakhstan.

China RoHS marking

The People's Republic of China Electronic Industry Standard (SJ/T 11364-2014)
specifies the marking requirements for hazardous substances in electronic and electrical
products. The green mark is attached to the drive to verify that it does not contain toxic and
hazardous substances or elements above the maximum concentration values, and that it
is an environmentally-friendly product which can be recycled and reused.
„
Protection classes (page
Technical data 199
190).