Terminal And Entry Data For The Power Cables; Iec - Standard Configuration; Iec - With Option +E205; Us - Standard Configuration - ABB ACS580-07 Hardware Manual

160 Technical data

Terminal and entry data for the power cables

There are two (in frames R6 to R9) or four (in frames R10 and R11) 60 mm (2.36 in) diameter
holes in the entry plate for the input power cables and two (in frames R6 to R9) or four (in
frames R10 and R11) 60 mm (2.36 in) diameter holes for the motor cables.
￭ IEC – Standard configuration
Input and motor cable terminal bolt sizes, accepted wire sizes (per three phases) and
tightening torques are given below.
Frame
size
Max. wire
size
2
mm
R6 3×150
R7 2×(3×240)
R8 2×(3×150)
R9 2×(3×240)
R10 4×(3×150)
R11 4×(3×240)
1)
Note: Minimum wire size does not necessarily have enough current capability for full load.
Make sure the installation complies with local laws and regulations.
￭ IEC – With option +E205
Input and motor cable terminal bolt sizes, maximum accepted wire sizes (per three phases)
and tightening torques are given below.
Frame size
Max. wire size
R6 3×120
R7 3×240
R8 2×(3×120)
R9 2×(3×240)
R10 4×(3×150)
R11 4×(3×240)
￭ US – Standard configuration
Input and motor cable terminal bolt sizes, accepted wire sizes (per three phases) and
tightening torques are given below.
Input and motor cable connection terminals
L1, L2, L3
Bolt size Tighten-
ing torque
N·m
M10 20...40
M10 20...40
M10 20...40
M12 50...75
M12 50...75
M12 50...75
L1, L2, L3, U2, V2, W2
Bolt size
2
mm
M10
M10
M10
M12
M12
M12
T1/U2, T2/V2, T3/W2
Min. wire Max. wire
1)
size size ing torque
2 2
mm mm
3×25 3×150
2×(3×95) 2×(3×240)
2×(3×50) 2×(3×150)
2×(3×95) 2×(3×240)
- 4×(3×150)
- 4×(3×240)
Tightening
torque
N·m
20...40
20...40
20...40
50...75
50...75
50...75
PE (grounding) termin-
als
Tighten- Bolt size
ing torque
2
mm
N·m
30 M10
40 M10
40 M10
70 M10
50...75 M10
50...75 M10
PE (grounding)
Bolt size Tightening
torque
2
mm
N·m
M10 30...44
M10 30...44
M10 30...44
M10 30...44
M10 30...44
M10 30...44
Tighten-
N·m
30...44
30...44
30...44
30...44
30...44
30...44