Connecting External Wiring To The Control Unit Or Optional I/O Terminal Block - ABB ACS580-07 Hardware Manual
General purpose drives
Hide thumbs
Also See for ACS580-07:
- User manual (36 pages) ,
- Hardware manual (288 pages) ,
- User manual (40 pages)
Table of Contents
Advertisement
88 Electrical installation
The route of the control cables for frames R10 and R11 is shown below.
X504 (+L504)
￭
Connecting external wiring to the control unit or optional I/O terminal
block
Note:
Keep any signal wire pairs twisted as close to the terminals as possible. Twisting the wire
with its return wire reduces disturbances caused by inductive coupling.
Note:
Leave slack to the control wires to make it possible to lift the control unit mounting plate a
little when the drive module is replaced.
Ground the pair-cable shields and all grounding wires to the grounding clamp.
Advertisement
Table of Contents
