Type Designation Label; Type Designation Key - ABB ACS580-07 Hardware Manual

„
• stranded wire without ferrule 0.2 to 2.5 mm
Stripping length: 10 mm (0.5 in).
Note:
The option modules inserted in the slots of the control unit are not wired to the additional
terminal block. The customer must connect the option module control wires directly to the
modules.

Type designation label

The type designation label includes an IEC rating, appropriate markings, a type designation
and a serial number, which allow identification of each unit. The type designation label is
located on the front cover. An example label is shown below.
2
3
4
5
1 Type designation, see section
2 Manufacturing address
3 Frame size
4 Cooling method
5 Degree of protection
6
Ratings, see section
connection data (page
7
Short-circuit withstand strength, see section
8 Valid markings
9 Serial number. The first digit of the serial number refers to the manufacturing plant. The next four digits
refer to the unit's manufacturing year and week, respectively. The remaining digits complete the serial
number so that there are no two units with the same number.

Type designation key

The type designation contains information on the specifications and configuration of the
drive. The first digits from left express the basic configuration (eg, ACS580-07-0640A-4).
The optional selections are given thereafter, separated by plus signs, eg, +B055. The main
selections are described below. Not all selections are available for all types or with all options.
For more information, refer to ACX580-07 Ordering Information (3AXD10000485076 available
on request).
1
6
7
Type designation key
Ratings (page 149), Electrical power network specification (page 189)
189).
Operation principle and hardware description 41
2
(24 to 12 AWG).
below.
Electrical power network specification (page
8
9
and Motor
189).