Replacing The Drive Module (Frames R6 To R9) - ABB ACS580-07 Hardware Manual

126 Maintenance
3

Replacing the drive module (frames R6 to R9)

This replacing procedure requires: preferably two persons, a set of screw drivers with
extension bar and a torque wrench, chains for securing the module during the installation.
The drawings below show a cabinet of frame size R7. The procedure is the same for the
other frame sizes.
WARNING!
Obey the instructions in chapter
injury or death, or damage to the equipment can occur.
Handle the drive module carefully:
•
•
1. Stop the drive and do the steps in section
you start the work.
2. Open the cabinet door.
3. To attach the sliding rails:
3 a) Remove the sliding rails (2 pcs) from the left-hand side cabinet frame.
3 b) Undo the four screws from the top horizontal studs.
3 c) Attach the left-hand side sliding rail to the horizontal stud with the removed screws
3 d) Attach the right-hand side sliding rail to the horizontal stud with the removed screws.
WARNING!
Check that the stopping screws (3e) at the ends of the studs are in place, so
that the drive module cannot slide off the rail.
Use safety shoes with a metal toe cap to avoid foot injury.
Lift the drive module only by the lifting lugs.
4
Safety instructions. If you ignore them,
Electrical safety precautions (page 16) before