Configuring The Spectralink Ip-Dect Server/Spectralink Dect Media Resource Solution - SpectraLink IP-DECT 200 Installation And Configuration Manual

Spectralink IP-DECT Server 200/400/6500 Installation and Configuration Guide
Configuring the Spectralink IP-DECT
Server/Spectralink DECT Media Resource
Solution
This section provides you with information on basic network configuration of the Spectralink IP-
DECT Server 200/400/6500/Spectralink DECT Media Resource solution and the web based Admin-
istration Page.
Note:
Configuration of Spectralink DECT Media Resources and Clusters is not relevant to the
Spectralink IP-DECT Server 200/400.
Configuration of Spectralink IP-DECT Base Stations is not relevant to the Spectralink IP-
DECT Server 200.
The web based Administration Page is used to configure the different components of the Spectralink
IP-DECT Server solution.
Basic network settings can be obtained the following ways:
From a DHCP server
l
Using DHCP the device requests and obtains an available IP address from a DHCP server.
The device also obtains other parameters such as the default gateway, subnet mask, DNS
server, Time server and other IP parameters from the DHCP server.
Entered manually through web based Administration Page > Configuration > General >
l
General Configuration page.
Using manual network configuration, the IP-addresses and other networking parameters are
entered manually through the web based Administration Page.
14215700-IG, Edition 8.0
April 2018, Original document
84