SpectraLink IP-DECT 200 Installation And Configuration Manual page 132

Spectralink IP-DECT Server 200/400/6500 Installation and Configuration Guide
To define system wide settings:
1. Click Configuration, then click Wireless Server.
2. On the Wireless Server configuration page, under
chronization options in
type of service:
Field
Wireless Server Configuration - DECT
Subscription allowed (Optional)
Authenticate calls (Optional)
Encrypt voice/data (Optional)
System access code (Optional)
Send date and time (Optional)
System TX power (Optional)
Wireless Server Configuration - Media resources (Not relevant to the Spectralink IP-
DECT Server 200/400)
Allow new (Optional)
14215700-IG, Edition 8.0
April 2018, Original document
Default sync type, LAN sync transport protocol
If enabled, it is possible to subscribe new handsets to
the system.
If enabled, each individual DECT call will be authen-
ticated.
Encryption of voice/data packets transmitted via
DECT.
Possible values: Disabled, Enabled or Enforced
(non GAP).
Default value: Disabled
System wide DECT access code.
The access code is from 0 - 8 decimal digits.
Note: Individual user access code (AC) has pre-
cedence over system access code.
If enabled, date and time will be sent to the handsets
when a call is terminated.
Default value: Enabled
Used for controlling (reducing) the output power of all
connected base stations supporting power control.
Unless set to default, this will override any base station
specific power setting.
Default value: Default (250 mW)
Note: It is possible to define a TX power value for a
specific base station (Administration > Base Sta-
tion).
If enabled, new media resources are allowed to con-
nect to the server.
Base stations, set the desired syn-
and LAN sync
132