Status - Network Diagnose; Configuration - General - SpectraLink IP-DECT 200 Installation And Configuration Manual

Spectralink IP-DECT Server 200/400/6500 Installation and Configuration Guide

Status - Network Diagnose

Field
Network Diagnose
Host

Configuration - General

Field
General Configuration - IPv4
Method
IP addr
Netmask
Gateway
MTU (Maximum Translation
Unit) (Optional)
14215700-IG, Edition 8.0
April 2018, Original document
Enter the relevant IP address or domain name.
Click Ping to send a ping request to the host to check if net-
work is connected.
Click Trace route if you want to trace the route to the host.
Setting
Default value: DHCP assigned (dynamic IP address)
Select Use Static IP Address to configure a static IP address.
Note: When using a static IP address, it is also necessary to
configure other network settings below such as DNS and NTP
settings.
For more information, see also
figuration" on page 85.
Enter the IP address of the Spectralink IP-DECT Server.
Enter a new network mask. Contact your system administrator
for more information.
Enter the IP address of the default gateway.
The default gateway serves as an access point to another net-
work.
Contact your system administrator for more information.
Enter the size of the largest packet, that your network protocol
can transmit.
"Recommended Network Con-
226