To Update Spectralink Ip-Dect Server Firmware - SpectraLink IP-DECT 200 Installation And Configuration Manual

Spectralink IP-DECT Server 200/400/6500 Installation and Configuration Guide

To Update Spectralink IP-DECT Server Firmware

1. Click Firmware, and then click Wireless Server.
2. On the Update firmware page, click Browse to find the relevant firmware file.
Enable the Use firmware as default check box if you want the server firmware as default for
all base stations and media resources (recommended).
Click Update.
Wait until the system has finished updating.
Caution:
Do not cut power.
3. Click Reboot now or Back. Clicking Back, you have the option to make further changes
before the update is started.
4. Optionally, you can block new calls during a firmware update by clicking Administration, and
then clicking Wireless Server.
On the Wireless Server page, under Service Status, click Block.
5. Click Reboot now or Reboot when idle.
14215700-IG, Edition 8.0
April 2018, Original document
153