SpectraLink IP-DECT 200 Installation And Configuration Manual page 257

Spectralink IP-DECT Server 200/400/6500 Installation and Configuration Guide
Field
External antenna mode (Optional)
Base Station - Synchronization
Type
Auto radio sync (deployment only)
(Optional)
Primary radio sync (RPN)
(Optional)
Secondary radio sync (RPN)
(Optional)
Base Station - RSSI map (Only visible if more than one base station on the system)
RPN/RSSI dB/Offset
14215700-IG, Edition 8.0
April 2018, Original document
Determines which antenna(s) are used when an external
antenna is connected.
Possible values: Use Internal & external antenna, Use
internal antenna only or Use external antenna only.
Default value: Use Internal & external antenna
Note: This setting is ignored when no external antenna is con-
nected.
Note: When using external antenna, the range is reduced by
up to 50 %.
This setting controls the synchronization type used for the
specific base station/DECT radio.
Possible values: Free running, Radio, LAN or Radio/LAN
Gateway.
Select Free running, if you want to configure this base sta-
tion as sync master. Otherwise select either Radio, LAN or
Radio/LAN Gateway, depending on the synchronization
method.
Default value: Radio
Note: System wide settings for synchronization are located
under Configuration > Wireless Server > Base stations.
For more information, see Synchronization and Deployment
Guide.
If enabled, the base station will be auto synchronized while
deploying the system.
Note: This must only be used while deploying the system.
RPN identifying the base station used for primary radio syn-
chronization.
RPN identifying the base station used for secondary radio
synchronization.
Possible to see the RSSI values of the base stations the
selected base station is synchronizing on (Primary syn-
c/Secondary (Alternative) sync).
For more information about RSSI values, see Syn-
chronization and Deployment Guide.
257