Configuring Media Resource Settings - SpectraLink IP-DECT 200 Installation And Configuration Manual

Spectralink IP-DECT Server 200/400/6500 Installation and Configuration Guide

Configuring Media Resource Settings

Note:
Not relevant to the Spectralink IP-DECT Server 200/400.
To use the internal media resource, this must be enabled. To configure media resource settings from
the web based Administration Page:
1. Click Configuration, and then click Media Resource.
2. On the Media Resource Configuration page, enter the following data:
Field
Media Resource Configuration - Media resource
Enable internal
3. Click Save.
14215700-IG, Edition 8.0
April 2018, Original document
If enabled, the internal media resource will start up and
connect.
If disabled, CPU power is increased. Additional media
resource will take over then, if installed.
Default value: Enabled
115