Firmware - Handset - SpectraLink IP-DECT 200 Installation And Configuration Manual

Spectralink IP-DECT Server 200/400/6500 Installation and Configuration Guide
Field
Update base station firmware - Manual
Firmware file (Optional)
Start base station No
End base station No

Firmware - Handset

Field
Handset update settings - Automatic update
Enable (Optional)
Only in charger (Optional)
Start time (Optional)
System load (Optional)
14215700-IG, Edition 8.0
April 2018, Original document
Setting
Click Save.
The firmware file can be either a previously uploaded default
firmware file, or a new firmware file chosen. A new firmware file
has to be a valid firmware file with the extension .bin.
Select either Default or Upload.
The index number of the first base station to be updated.
You can check base station numbers under Administration >
base stations > IP Base Stations.
The index number of the last base station to be updated.
Setting
Enable.
This will make automatic update possible.
If enabled, only handsets in charger will be updated.
Default value: Immediately
If you want to upload later, select an appropriate time within
the next 24 hours.
Select relevant upload capacity. The load corresponds to the
number of maximum simultaneous updates.
Possible values: Low, Medium or High.
Default value: Medium
Low: 1 handset at a time. Medium: 4 handsets per media
resource. High: 16 handsets per media resource.
Example: 2 media resources and High load = 2*16 = 32 sim-
ultaneous updates.
Note: If you schedule an upgrade during day hours, you
would typically choose Low to Medium load to avoid any
impact on Users. Upgrade after hours typically means no
User load, therefore, you can choose High priority.
264