Resetting System To Factory Settings; To Reset System - SpectraLink IP-DECT 200 Installation And Configuration Manual

Spectralink IP-DECT Server 200/400/6500 Installation and Configuration Guide

Resetting System to Factory Settings

Through the web based Administration Page of the Spectralink IP-DECT Server it is possible to
reset the Spectralink IP-DECT Server to factory default settings (original configurations and empty
user data base). Firmware version is not affected.
Note:
You can also reset the Spectralink IP-DECT Server and Spectralink DECT Media
Resource to factory settings by pressing the Reset button. For more information, see
"Server and Media Resource Reset Button" on

To Reset System

1. Click Configuration, and then click Factory Reset.
2. Click Reset, and then click OK.
All configuration and user data are being erased and the system will reboot.
Note:
If you by mistake delete a license or perform a factory reset of the system (which will
delete all loaded licenses), it is possible to retrieve the license(s) again by entering the
ARI code of the Spectralink IP-DECT Server in the Spectralink License Key Generator
on Spectralink Corporation's support portal: http://support.spectralink.com/keycode.
In the ARI (DECT) / Serial number (Wi-Fi) field, enter the ARI, and click
l
Submit.
Copy the license(s) into the web based Administration Page (Administration >
l
License > Licenses > Load license) and click Load.
If the license does not appear when entering the ARI of the system, contact
nicalsupport@spectralink.com.
14215700-IG, Edition 8.0
April 2018, Original document
page 57.
Tech-
170