Base Station Led Indicators; Front Cover; Lan Port On Face Plate; Base Station Reset Button - SpectraLink IP-DECT 200 Installation And Configuration Manual

Spectralink IP-DECT Server 200/400/6500 Installation and Configuration Guide

Base Station LED Indicators

Below you will find information about LED indicators on the base station.

Front Cover

The base station front cover has one indicator describing the base station faults and failures. The
indicator is off when the base station is not powered. The LED flashes when the base station ini-
tializes. The indicator is on when the base station is operating.
LED Indicator
Steady green
Slow green flashing
Fast green flashing
Slow red flashing
Fast red flashing
Steady red
Steady red for 5 seconds followed by
fast red flashing

LAN Port on Face Plate

LED Indicator
LINK Indicator - yellow
LINK Indicator - green flashing

Base Station Reset Button

You can restart or reset the base station by pressing the Reset button on the bottom of face plate of
the base station.
The following table contains a description of the different actions that take place when pressing the
Reset button.
Press button
Short press (2 to 5 sec.)
Long press (5 to 9 sec.) until front LED
flashes red, then release button
14215700-IG, Edition 8.0
April 2018, Original document
Meaning
OK and idle.
OK and active voice call.
Busy (all channels are in use).
No server connection.
No sync over air possible, or sync master is not avail-
able, or other error.
Reset/shutdown in progress.
Reset to factory settings.
Meaning
Link layer software has established connection.
Activity
Action
System restarts when button is released.
Resets the system to factory default settings (original IP
settings - DHCP) and restarts the system. Firmware ver-
sion is not affected.
65