Repeater Led Indicators; Front Cover; Site Installation Considerations; Environmental Considerations - SpectraLink IP-DECT 200 Installation And Configuration Manual

Spectralink IP-DECT Server 200/400/6500 Installation and Configuration Guide

Repeater LED Indicators

Below you will find information about LED indicators on the repeater.

Front Cover

LED Indicator
Indicator Off
Flashing
Steady green
Short flash

Site Installation Considerations

Before you begin the installation, determine the position of the repeater for best coverage. The cov-
erage depends on the construction of the building and the choice of building materials.
The repeater can be registered on the system under the following circumstances.
When placed within the coverage area of a base station/server 200/400
l
When placed within the coverage area of an already-installed repeater
l
When placed outside the coverage area of a base station or repeater using an external
l
antenna.
Note:
The repeater does not add channels. It only adds additional coverage area.

Environmental Considerations

Do not install a device near metal objects and steel constructions.
l
Do not position devices in ducts, plenums or hollow spaces used to transport environmentalair
l
except where the duct, plenum or hollow space is created by a suspended ceiling having lay-in
panels.
Do not position devices behind furniture.
l
The installation area must be clean, free of traffic and excess dust, dry, and well ventilated.
l
The installation area must be within the temperature ranges of 10°C and 40°C/50°F and
l
104°F.
The installation area must be between 20% and 80% non-condensing relative humidity.
l
For best RF coverage, the device must be mounted vertically on walls.
l
14215700-IG, Edition 8.0
April 2018, Original document
Meaning
The repeater is not powered.
Repeater has been powered, sync has still not been
established.
The repeater is powered and sync is established.
A handset connects or makes handover to the repeater.
70