Carriage Belt Clamp - ENCAD T200+ Service Manual

BUMP
Figure 5-12. Carriage Belt Clamp.
12. Push the Carriage Belt away from the right post of the Belt
Clamp and gently lift up to finish removing the Carriage Belt
from the Belt Clamp.
Failure to use an approved antistatic bag for storage or
shipment may cause damage to the MPWA and affect
the Warranty.
13. Place the Carriage Assembly in an ESD (antistatic) bag in
preparation for shipment to ENCAD for replacement or repair, or
if it is to be stored for repair at your facility.
ENCAD T-200 and T-200+ Service Manual
CARRIAGE BELT
RIGHT POST OF
BELT CLAMP
LEFT POST OF
BELT CLAMP
CAUTION
Assembly\Disassembly 5-19