Select Time Program - Roth EnergyLogic Touchline/wireless User Manual

User Manual Roth EnergyLogic Touchline/Wireless
Commissioning and operation
NOTE
7.6.3

Select time program

66
The temperature difference between "Normal operation" and "Reduced
operation" can be set individually for each wireless room thermostat. The
factory setting is 3 K.
In operating mode "Reduced operation", the display shows the setpoint of
the operating mode "Normal operation". The setpoint is internally reduced
by the set temperature difference, however.

See parameter description P-44, page 89.
In the mode of operation "time program" one of the three time programs I, II,
or III can be selected. The time programs are shown with the symbols
or . If the symbol
gram is active. If only the symbol
the "ECO" input of the wireless connection module is active.
The wireless room thermostat is in stand-by mode.
►
Press the sensor button
times until the symbol
►
Press the sensor buttons
Corresponding to the symbols the display also shows Pro1, Pro2 or Pro3.
►
Press sensor button
– If no sensor button is pressed, the selection is interrupted after 10 sec-
onds and the wireless room thermostat returns into stand-by mode. The
new mode of operation is not saved.
– Press the sensor button
of operation is not saved.
and the message OFF is shown, then no time pro-
without the message OFF is shown, then
at the wireless room thermostat briefly several
blinks. The display shows OFF.
or , to select time program I, II, III, or OFF.
, to confirm the selected time program.
, to interrupt the procedure. The new mode
, ,
P100011294 E