Zones; Zone Building, Assign Radio Channels To One Zone - Roth EnergyLogic Touchline/wireless User Manual

7.2

Zones

Applications for zoning
7.2.1

Zone building, assign radio channels to one zone

NOTE
Build first zone
Build second zone
P100011294 E
Each wireless connection module can be divided in up to 3 zones.
Zones can be used for the following applications:
●
Within one zone the modes of operation, "Off (frost protection)", "Eco",
"Normal Operation" or the same time program will be shared. The mode or
the operation can be changed at each wireless room thermostat.
●
One wireless room thermostat will have the highest priority for heating and
cooling. The change of mode will transferred to all wireless room thermo-
stats within the zone.  See parameter description P-51, page 92.
●
One wireless room thermostat will be assigned as master. With this wire-
less room thermostat there are following possibilities available:
– Changing the mode of operation.
– Changing the time program for the wireless connection module.
– Selecting the mode of operation heating/cooling for the entire plant.
 See parameter description P-48, page 91.
●
All wireless room thermostats share the same setpoint within the zone.
 See parameter description P-46, page 90.
In the following example three zones are built. However, it is also possible
to build one or two zones only, and to keep certain channels outside the
zone(s).
Zoning building can be done only after the assignment of the wireless
room thermostats to radio channels. After zoning building it is possible to
add any wireless room thermostat to a zone.
►
Press push button Zone at the wireless connection module briefly.
►
The green Power LED blinks.
►
The blue LED indicating the first zone and the CH LEDs for channels not
yet assigned to a zone blink.
►
Press the CH buttons for the radio channels that need to be assigned to
the first zone.
►
The LEDs of the assigned channels light.
►
Press push button Zone at the wireless connection module briefly.
►
The red LED indicating the second zone and the CH LEDs for channels not
yet assigned to a zone blink.
►
Press the CH buttons for the radio channels that need to be assigned to
the second zone.
►
The LEDs of the assigned channels light.
User Manual Roth EnergyLogic Touchline/Wireless
Commissioning and operation
59