Change Setpoints; Set Room Temperature; Set Floor Temperature - Roth EnergyLogic Touchline/wireless User Manual

7.3

Change setpoints

7.3.1

Set room temperature

7.3.2

Set floor temperature

> 5 s
SET TEMP
P100011294 E
The wireless room thermostat is in stand-by mode.
►
Press any button on the wireless room thermostat for 2 seconds.
►
The display changes into operation mode. The setpoint blinks.
►
Press sensor button
►
Press sensor button
– If no sensor button is pressed, then the new setpoint will be automati-
cally saved after 5 seconds.
– To interrupt this procedure press the sensor button
point will not be saved.
►
If no sensor button is pressed, the wireless room thermostat returns into
stand-by mode.
The setting of the floor temperature is only available for the type with IR floor
temperature measurement.
The wireless room thermostat is in stand-by mode.
►
Press any button on the wireless room thermostat for 2 seconds.
►
The display changes into operation mode. The room temperature setpoint
blinks.
►
Press sensor button
shows P01.
►
Press sensor button
►
Press sensor button
perature and the symbol
►
Press sensor button
►
Select one of the following options:
– Press sensor button
P03.
– Press sensor button
not saved. The display shows P02.
– If no sensor button is pressed, the wireless room thermostat returns into
stand-by mode after 1 minute. The new setpoint is not saved.
►
To leave the user menu press sensor button
operation mode.
User Manual Roth EnergyLogic Touchline/Wireless
Commissioning and operation
or , to change the setpoint.
to confirm the new setpoint.
5 seconds to enter the user menu. The display
. The display shows P02.
. The display shows the setpoint for the floor tem-
.
or , to change the setpoint.
to confirm the new setpoint. The display shows
, to interrupt the procedure. The new setpoint is
. The new set-
. The display shows the
61