Making Measurements Using Sensor Calibration Tables - Agilent Technologies E4419B User Manual

2 Power Meter Operation

Making Measurements using Sensor Calibration Tables

This section applies to all Agilent 8480 Series power sensors and N8480 Series
power sensors with Option CFT. It does not apply to the Agilent E-Series
power sensors or N8480 Series power sensors (excluding Option CFT).
For the Agilent 8480 Series power sensors and N8480 Series power sensors
with Option CFT, there are two methods of providing correction data to the
power meter:
This section describes how to use sensor calibration tables. Sensor calibration
tables are used to store the measurement calibration factors, supplied with
each power sensor in the power meter. These calibration factors are used to
correct measurement results.
Using sensor calibration tables provides you with a quick and convenient
method for making power measurements over a range of frequencies using one
or more power sensors. The power meter is capable of storing 20 sensor
calibration tables of 80 frequency points each.
To use sensor calibration tables, you:
1 Select the table to work on a channel. Refer to
2 Zero and calibrate the power meter. The reference calibration factor used
3 Specify the frequency of the signal you want to measure. The calibration
4 Make the measurement.
46
a inputting the individual calibration factor for a frequency prior to
making the measurement, or
b using sensor calibration tables.
Calibration Table" on page 47 for further information. If you are required to
edit the table, refer to
further information.
during the calibration is automatically set by the power meter from the
sensor calibration table.
factor is automatically set by the power meter from the sensor calibration
table. Refer to "Making the Measurement"
information.
"Editing Sensor Calibration Tables"
on page 48 for further
"Selecting a Sensor
on page 49 for
E4419B Power Meter User's Guide