Agilent Technologies E4419B User Manual page 27

3
4 "System/Inputs" key with softkey menu.
5
6 Dedicated "Window" keys with softkey menus.
7 Dedicated "Channel" keys with softkey menus.
8 Channel Inputs.
9 POWER REF Output.
E4419B Power Meter User's Guide
This key switches the power meter between on and standby. When the
power meter is switched to standby (that is, when this key has not been
selected but the line power is connected to the instrument), the red LED is
lit. When the power meter is switched on, the green LED is lit.
Option 001 Battery: On standby with the battery installed and the AC
power source disconnected, the red LED is off.
The key allows access to softkey menus which affect the general
power meter system setup, (for example, the GPIB address) and also to
softkey menus which effect the setup of the channel inputs. Refer to
Chapter 3 for further information about this key and its softkey menu.
This key is the only one that is completely dedicated to the control of the
power meter as a system. The only other key which affects system
parameters is the
about this key and its softkey menu.
, ,
These keys allow access to softkey menus which affect the setup of the
measurement windows. Refer to
these keys and their softkey menus.
,
These keys allow access to softkey menus which affect the measurement
channel. Refer to Chapter 3
their softkey menus.
The Agilent E4419B has two sensor inputs. Power meters configured with
Options 002 or 003 have the sensor inputs on the rear panel and the front
panel.
The power reference output is a 50 Ω type-N connector. The output signal of
1 mW at 50 MHz is used for calibrating the sensor and meter combination.
key. Refer to Chapter 3
Chapter 3 for further information about
for further information about these keys and
Getting Started
for further information
1
5