Agilent Technologies E4419B User Manual page 64

2 Power Meter Operation
8 To confirm your choice, press the appropriate frequency units.
9 Connect the power sensor to the signal to be measured.
10 You must set the display to the type of measurement you require. This can
11 The measurement result is now displayed.
Example
To make a measurement on channel A using an Agilent E-Series power sensor.
The frequency of the signal to be measured is 100 MHz.
• Disconnect the power sensor from any source.
• Press
• Press
• Connect the power sensor to the POWER REF output.
• Press
• Press
• Connect the power sensor to the signal to be measured.
• The measurement result is now displayed.
42
• Use or to modify the digit on which the cursor is currently
positioned.
• Use or to move to other digits.
either be a direct channel measurement, a ratio measurement of both
channels or a difference measurement between both channels. Use the
following key presses:
Press ,
Input Select
measurement you require, either
.
B-A
.
.
Zero A
, .
Cal Cal A
, A Freq
100. Press .
MHz
. Select the appropriate softkey for the
, , ,
A B A/B B/A
. Use the , ,
E4419B Power Meter User's Guide
, or , then
A-B
, and keys to enter
or