Agilent Technologies E4419B User Manual page 152

3 Menu Reference
•
•
• Press this softkey to choose from four levels of resolution. The resolution
•
130
Display Format
Press this softkey to access a menu which allows you to select digital or
analog displays, set the resolution and set the limits for the analog display.
Meter Dgtl Anlg
•
Press this softkey to toggle between an analog and digital display. Refer
to "Selecting a Digital or Analog Display"
information.
Anlg Mtr Scaling
•
Press this softkey to access a menu which allows you to enter the
maximum and minimum scale limits shown on the analog display.
Max
■
Press this softkey to enter the maximum scale value shown on the
analog display.
Min
■
Press this softkey to enter the minimum scale value shown on the
analog display.
Resolution 1 2 3 4
can be specified in dB or digits depending on the measurement suffix used.
The suffix used is the one which is selected in the
levels (1, 2, 3, 4) represent:
1, 0.1, 0.01, 0.001 dB respectively if the measurement suffix is dBm or dB. 1,
2, 3, or 4 significant digits respectively if the measurement suffix is W or %.
The default value is 3 (that is, 0.01 dB or 3 digits).
Limits
Press this softkey to access a menu where you can enter upper and lower
limits for each display window which when exceeded will output a TTL
logic level (if enabled) at the rear panel TTL outputs. Refer to
Window Limits" on page 75 for further information.
Limits Off On
•
Press this softkey to toggle between the test limits being on or off. The
default is "Off".
on page 82 for further
menu. These four
"Setting
E4419B Power Meter User's Guide