Agilent Technologies E4419B User Manual page 73

Predefined sensor calibration factor table stored in power meter is not applicable for
N O T E
Agilent N8480 Series power sensors with Option CFT. Therefore, users are required to
create a new sensor calibration table for the respective sensors when a sensor calibration
table is needed.
You cannot delete any of the 20 sensor calibration tables. Each sensor
calibration table can contain a maximum of 80 frequency points each. If you
want a new sensor calibration table, you must edit an existing one.
To edit a table:
1 Select one using the
2 To edit the parameter you currently have selected, press
3 To confirm your choice, press the appropriate softkey.
4 To add a new sensor calibration table entry, press
E4419B Power Meter User's Guide
tables. When the table you want to edit is highlighted, press
The "Edit Cal" screen is displayed as shown in
screen, you can modify, add, remove frequency and calibration factors and
also edit the table name. Use the
between the table name and its frequency and calibration factors.
A frequency in the range of 0.001 MHz to 999.999 GHz can be entered.
A calibration factor in the range of 1% to 150% can be entered.
The following rules apply to naming sensor calibration tables:
• The name must consist of no more than 12 characters.
• All characters must be upper or lower case alphabetic characters or
numeric (0-9) or an underscore (_).
• No other characters are allowed.
• No spaces are allowed in the name.
meter displays the data in a pop-up window. Modify this data (see below) as
desired.
• Use or
positioned.
• Use or
for the frequency and calibration factor. The entry is sorted by frequency.
and keys to scroll through the displayed
,
to modify the character on which the cursor is currently
to move to other characters.
Power Meter Operation
Edit Table
Figure 2-5 on page
, , and keys to move
Change
Insert . You are prompted
2
.
50. In this
. The power
51