Agilent Technologies E4419B User Manual page 105

To select the format of the display in the currently selected window:
1 Press
2 Press
To select the range of the analog display in the currently selected window:
1 Press
2 The current setting of the maximum and minimum values displayed on the
3 To change either of these settings, press the appropriate softkey. The power
4 The choices available depend on the unit of measurement selected and the
Pressing
decreases the multiplier shown in front of
correct multiplier has been selected confirms the entry.
E4419B Power Meter User's Guide
, Display Format
Meter Dgtl Anlg
this key toggles between a digital and analog display.
, Display Format Meter Dgtl Anlg
analog meter are displayed under the
meter displays the current value in a pop-up window. Modify this value (see
below) until the desired value is displayed.
• Use or to modify the digit on which the cursor is currently
positioned.
• Use or to move to other digits.
current measurement mode. If the measurement unit selected is
logarithmic, then the choice will be
selected is linear, then choose the appropriate softkeys from the following
menus:
Increment Multiplier
.
to highlight the type of format you require. Pressing
,
Max and
dB or dBm
%
Cancel
%
Increment
Multiplier
Decrement
Multiplier
Cancel
or Decrement Multiplier
or
%
Power Meter Operation
.
Min softkeys respectively.
. If the measurement unit
mW
μ
W
nW
Cancel
W
Increment
Multiplier
Decrement
Multiplier
Cancel
increases or
. Pressing % ,or
W
W
2
after the
83