Dell PowerConnect J-EX4200-24T Software Manual page 3481

Table 450: RPM Probe Owner, Concurrent Probes, and Probe Servers Configuration Fields
Field
Probe Owners
Maximum Number of Concurrent Probes
NOTE:
J-EX Series switches support hardware timestamps for UDP and ICMP
probes. J-EX Series switches do not support hardware timestamps for
HTTP or TCP probes.
If the responder does not support hardware timestamps, RPM can only
report the round-trip measurements, it cannot calculate round-trip jitter.
In J-EX Series switches timestamps apply only to IPv4 traffic.
To configure RPM using the J-Web interface:
Select Troubleshoot >
1.
In the page, enter information as specified in Table 450 on page 3409.
2. Configure RPM
Click to set up the
a. Add
Select a probe owner from
b.
probe owner
Double-click one of the probe owners in
c.
performance probe tests.
Double-click one of the performance probe tests to edit the test parameters.
d.
Enter the
Maximum Number of Concurrent Probes
3.
Click to apply the RPM probe settings.
Apply
4.
Function
Identifies a owner for whom one or more
RPM tests are configured. In most
implementations, the owner name
identifies a network on which a set of
tests is being run.
Specifies the maximum number of
concurrent probes allowed.
Chapter 129: Real-Time Performance Monitoring (RPM)
RPM > Configure RPM .
and
Owner Name Performance Probe Tests
list and click
Probe Owners
Probe Owners
.
to remove the selected
Delete
list to display the list of
and specify the
Probe Servers
Your Action
1. Click Add and type an owner name.
2. In Performance Probe Tests
to define the RPM test parameters.
See Table 451 on page 3410 for
information on configuring RPM test
parameters.
3. Click OK to save the settings or
to exit from the window
Cancel
without saving the changes.
Type a number from 1 through 500.
.
, click Add
3409