Dell PowerConnect J-EX4200-24T Software Manual page 3487

icmp-ping
icmp-ping-timestamp
udp-ping
udp-ping-timestamp
To configure RPM probes and enable hardware timestamping:
Specify the probe owner:
1.
[edit services rpm]
user@switch# set probe owner
Specify a test name. A test represents the range of probes over which the standard
2.
deviation, average, and jitter are calculated.
[edit services rpm probe owner]
user@switch# set test test-name
Specify the packet and protocol contents of the probe:
3.
[edit services rpm probe owner test test-name]
user@switch# set probe-type type
Specify the destination IPv4 address to be used for the probes:
4.
[edit services rpm probe owner test test-name]
user@switch# set target address address
Specify the number of probes within a test:
5.
[edit services rpm probe owner test test-name]
user@switch# set probe-count count
Specify the time, in seconds, to wait between sending packets:
6.
[edit services rpm probe owner test test-name]
user@switch# set probe-interval interval
Specify the time, in seconds, to wait between tests:
7.
[edit services rpm probe owner test test-name]
user@switch# set test-interval interval
Specify the source IP address to be used for probes. If the source IP address is not
8.
one of the switch's assigned addresses, the packet uses the outgoing interface's
address as its source.
[edit services rpm probe owner test test-name]
user@switch# set source-address address
Specify the value of the Differentiated Services (DiffServ) field within the IP header.
9.
The DiffServ code point (DSCP) bits value must be set to a valid 6-bit pattern.
[edit services rpm probe owner test test-name]
user@switch# set dscp-code-point dscp-bits
If you are using ICMP probes, specify the size of the data portion of ICMP probes:
10.
[edit services rpm probe owner test test-name]
Chapter 129: Real-Time Performance Monitoring (RPM)
3415