Setup Dmz1, Lan1 Status - Planet Networking & Communication MH-5001 User Manual

MH-5001 User Manual
DNS IP Address:
Primary DNS
Secondary DNS
Routing Protocol
OSPF Area ID
Default WAN
link
(Gateway/DNS)
Service Name
User Name
PPP over
Password
Ethernet
Get DNS
Automatically /
DNS IP Address

3.4.2 Setup DMZ1, LAN1 Status

Step 1. Setup DMZ port
Here we are going to configure the DMZ1
settings. Setup IP Address and IP Subnet
Mask, and determine if you would like to enable
the DHCP Server. And then select Routing
Protocol. Click Apply to finish this setting.
Specified Primary and Secondary DNS Server
address
Determine to enable the dynamic routing
protocol, to receive RIP message, to send out
the RIP message if the RIP message is received
or not.
Specify OSPF area ID number
When Default WAN link is enabled. All the
packets sent out from MH-5001 will be via this
port.
ISP vendor (Optional)
The user name of PPPoE account
The password of PPPoE account
Get DNS Automatically
information from PPPoE ISP
DNS IP Address
Primary and
information
Table 3-1 Detailed information of setup WAN port configuration
BASIC SETUP > DMZ Settings > DMZ1 Status
Get DNS related
manually specify these
Secondary DNS Server
33
Basic Setup
Primary DNS:
168.95.1.1
IPv4 format
Secondary DNS:
None,
RIPv1/In,
RIPv1/In+Out,
RIPv2/In,
RIPv2/In+Out,
OSPF
IPv4 format or
digit string (Max
9 bits)
Enable/Disable
text string
text string
text string
Get DNS
Automatically /
Automatically
DNS IP Address
Chapter 3
0.0.0.0
None
Enabled
So-Net
Hey
G54688
Get DNS