Setup Wan1 Ip - Planet Networking & Communication MH-5001 User Manual

MH-5001 User Manual
3.4 Steps

3.4.1 Setup WAN1 IP

Step 1. Setup WAN1 port
Here we select Fixed IP Address method in
WAN1 port. Fill in the IP Address, Subnet
Mask, Gateway IP. And then enter the other
DNS IP Address, Routing Protocol fields.
Click Apply to finish this setting.
IP Address
Assignment
Default WAN
link
(Gateway/DNS)
Get DNS
Automatically /
DNS IP Address
Get IP
Automatically
(DHCP)
Routing Protocol
OSPF Area ID
Default WAN
Fixed IP Address
link
(Gateway/DNS)
IP Address
Subnet Mask
Gateway IP
BASIC SETUP > WAN Settings > WAN1 IP > Fixed IP Address
FIELD
When Default WAN link is enabled, all the
packets sent out from MH-5001 will be via this
port.
Get DNS Automatically
information from DHCP Server
DNS IP Address
Primary
information
Determine to enable the dynamic routing
protocol, to receive RIP message, to send out
the RIP message if the RIP message is received
or not.
Specify OSPF area ID number
When Default WAN link is enabled. All the
packets sent out from MH-5001 will be via this
port.
Specified IP address
Specified subnet mask
Default gateway IP address
DESCRIPTION
Get DNS related
manually specify these
and Secondary DNS
32
Range / Format
Enable/Disable
Get DNS
Automatically /
DNS IP Address
Server
None,
RIPv1/In,
RIPv1/In+Out,
RIPv2/In,
RIPv2/In+Out,
OSPF
IPv4 format or
digit string (Max
9 bits)
Enable/Disable
IPv4 format
IPv4 format
IPv4 format
Chapter 3
Basic Setup
EXAMPLE
Enabled
Get DNS
Automatically
None
Enabled
61.2.1.1
255.255.255.248
61.2.1.6