Wiring The Mh-5001 - Planet Networking & Communication MH-5001 User Manual

MH-5001 User Manual
After you completely finished the above steps, the connectivity function of MH-5001 is probably well-done.
1.3

Wiring the MH-5001

A. First, connect the power cord to the socket at the back panel of the MH-5001 as in Figure 1- and then plug the
other end of the power adapter to a wall outlet or power strip. The Power LED will turn ON to indicate proper
operation.
B. Using an Ethernet cable, insert one end of the cable to the WAN port on the front panel of the MH-5001 and the
other end of the cable to a DSL or Cable modem, as in Figure 1-.
C. Computers with an Ethernet adapter can be directly connected to any of the LAN ports using a cross-over Ethernet
cable, as in Figure 1-.
D. Computers that act as servers to provide Internet services should be connected to the DMZ port using an Ethernet
Cable, as in Figure 1-.
1.4 Default Settings and architecture of MH-5001
You should have an Internet account already set up and have been given most of the following information as Table 1-1.
Fill out this table when you edit the web configuration of MH-5001.
Figure 1-4 Back panel of the MH-5001
Figure 1-5 Front end of the MH-5001
12
Chapter 1
Quick Start