Change Mh-5001 Interface - Planet Networking & Communication MH-5001 User Manual

MH-5001 User Manual
FIELD
Enable SNMP
System Name
System Location
Contact Info
Get community
Set Community
Trusted hosts
Trap community
Trap destination
Step 2. MH-5001 traps
The MH-5001 agent can send traps to the SNMP
trap receivers on your network that are configured
to receive traps from the MH-5001 when
rebooting. The MH-5001 agent sends traps in
response to the events listed in SNMP traps.

4.4.6 Change MH-5001 interface

Step 1. Change Interface definition
The default port settings are 2 WAN ports, 1 DMZ
port and 2 LAN ports. But in order to fit our
requirement. Here we select 3 WAN (port1~3), 1
DMZ (port4), 1 LAN (port5). And then press apply
button to reboot MH-5001. Note that the DMZ and
LAN port IP addresses are going to be 10.1.1.254
and 192.168.1.254 after device finishes reboot.
Besides, there should be at least one WAN port
and one LAN port existing in the MH-5001. You
are not allowed to casually change the interface
to the state which has no LAN port or WAN port.
Enable the SNMP function or not.
The device name of MH-5001.
The settled location of MH-5001.
The person who takes charge of the MH-5001.
The community which can get the SNMP information. Here
"community" is something like password.
The community which can get the SNMP information. Here
"community" is something like password.
The IP address which can get or set community from the MH-5001.
The community which will send SNMP trap. Here "community" is
something like password.
The IP address which will send SNMP trap from the MH-5001.
Table 4-8 SNMP Settings
SYSTEM TOOLS > Admin Settings > Interface
DESCRIPTION
47
Chapter 4
System Tools
EXAMPLE
Enabled
MH-5001.planet.com.tw
Office
mis
public-ro
private-rw
192.168.1.5
trap-comm
192.168.1.5