Steps - Planet Networking & Communication MH-5001 User Manual

MH-5001 User Manual

23.4 Steps

Step 1 – Enable IPS
Check the Enable IPS checkbox, and then click
the Apply button. When IPS enabled, priority-1
inbound/outbound attacks through the default
WAN link will be blocked. Priority 2-5 attacks will
only trigger alerts.
Step 3 – Consult Signature-based IPS
You can consult signature-based attack shown as
right diagram. The signature-based IPS can be
sorted by groups. Select DOS to list all DOS
category attacks. See Table 23-1
Step 4 - Consult Anomaly-based IPS
You can consult anomaly-based attacks shown
Table 23-1
as right diagram. See
ADVANCED SETTINGS > IPS > IPS Status
ADVANCED SETTINGS > IPS > Signature
for the details.
ADVANCED SETTINGS > IPS > IPS Status
for the details.
184
Chapter 23
Intrusion Prevention Systems