Ldap Setting - Planet Networking & Communication MH-5001 User Manual

MH-5001 User Manual
FIELD
Server IP The IP address of the RADIUS server.
Server Port The port which the data goes into or out of the RADIUS server.
Secret is the encryption key used by RADIUS to send authentication
Secret
information over a network.

6.3.5 LDAP Setting

Step 9. Configure LDAP Settings
If you have configured LDAP support and a user
is required to authenticate using a LDAP server,
the MH-5001 will then contact the LDAP server
for authentication. To authenticate with the
MH-5001, the user enters a username and
password. The MH-5001 sends this user name
and password to the LDAP server. If the LDAP
server can authenticate the user, the user is
successfully authenticated with the MH-5001.
Click Authentication Type as LDAP. Enter
LDAP and
Server IP
distinguished name (Base DN) used to look up
entries on the LDAP server. For example, you
can use the Base DN like ou=people,
dc=yourcompany,dc=com,dc=tw where ou is
organization unit and dc is domain component.
Enter the common name identifier in the UID
field. Note that UID (it may be named as cn) is
the field name in LDAP server. Please refer to
Table 6-4 for details.
FIELD
Server IP The IP address of the LDAP server.
The distinguished name used to look up entries on the LDAP server. For
example:
In OpenLDAP:
entry1: uid=mary,ou=people,dc= yourcompay,dc=com
entry2: uid=jack,ou=people,dc= yourcompay,dc=com
Base DN: ou=people,dc=yourcompany,dc=com
Base DN
UID : uid
In Windows AD (special case):
entry1: cn=mary,dc= yourcompay,dc=com
entry2: cn=jack ,dc= yourcompay,dc=com
Base DN: cn=Users,dc=yourcompany,dc=com
UID: cn
UID is the field name and used to look up entries on LDAP server. Please
UID
refer to the above description.
DESCRIPTION
Table 6-3 RADIUS Settings
Basic Setup > Authentication > Authentication > LDAP
then enter the
DESCRIPTION
Table 6-4 LDAP Settings
57
Chapter 6
Authentication
EXAMPLE
192.168.40.60
1812
wall
EXAMPLE
192.168.40.66
ou=people,dc=yourcompany,
dc=com,dc=tw
uid