Radius Setting - Planet Networking & Communication MH-5001 User Manual

MH-5001 User Manual
Encryption is the process of changing data into a form that can be read only by
the intended receiver. Secured Sockets Layer is a protocol that transmits your
communications over the Internet in an encrypted form. It ensures that the
Encryption
information is sent, unchanged, only to the server you intended to send it to.
Therefore, if you use port 995 (POP3s) as your server port, you have to check
SSL checkbox.
6.3.3 Imap(s) Setting
Step 7. Configure Imap(s) Settings
Click Authentication Type as Imap(s).
Enter Server IP and Server Port. Check the
Encryption as SSL. Click Apply to store the
settings. Note, if you enter server port as 143
(IMAP), don't check the SSL checkbox.
FIELD
Server IP The IP address of the IMAP(s) server.
The port which the data goes into or out of the IMAP(s) server. For instance,
Server Port
IMAP service uses port 143 and IMAPs service uses port 993.
Encryption is the process of changing data into a form that can be read only by
the intended receiver. Secured Sockets Layer (SSL) is a protocol that transmits
your communications over the Internet in an encrypted form. It ensures that the
Encryption
information is sent, unchanged, only to the server you intended to send it to.
Therefore, if you use port 993 (IMAPs) as your server port, you have to check
SSL checkbox.

6.3.4 Radius Setting

Step 8. Configure Radius Settings
If you have configured RADIUS support and a
user is required to authenticate using a RADIUS
server, the MH-5001 then will contact the
RADIUS server for authentication.
Click Authentication Type as Radius. Enter
Port and enter the
Server IP/Server
RADIUS Server Secret. Click Apply to store
the settings.
Table 6-1 POP3(s) Settings
Basic Setup > Authentication > Authentication > Imap(s)
DESCRIPTION
Table 6-2 IMAP(s) Settings
Basic Setup > Authentication > Authentication > Radius
56
Chapter 6
Authentication
EXAMPLE
10.1.1.1
993
SSL