Setting up the machine
2.7 Work offsets
2.7.7
Measuring the workpiece zero
Procedure
80
1.
Select the "Parameter" operating area and press the "Work offset"
softkey.
2.
Press the "G54...G599" softkey and select the work offset in which the
zero point is to be saved.
3.
Press the "Workpiece zero" softkey.
You change to the "Set Edge" window in the "JOG" mode.
4.
Traverse the tool in the Z direction and scratch it.
5.
Enter the position setpoint of the workpiece edge Z0 and press the
"Set WO" softkey.
Operating Manual, 07/2010, 6FC5398-8CP40-0BA0
Turning