Executing An Mda Program; Deleting An Mda Program - Siemens sinumerik 840D sl Operating Manual

2.11.3

Executing an MDA program

Proceed as follows
When executing the G-code commands, you can control the sequence as follows:
● Executing the program block-by-block
● Testing the program
● Setting the test-run feedrate
2.11.4

Deleting an MDA program

Precondition
The MDA editor contains a program that you created in the MDI window or loaded from the
program manager.
Procedure
Turning
Operating Manual, 07/2010, 6FC5398-8CP40-0BA0
1. Select the "Machine" operating area.
2. Press the <MDA> key.
The MDA editor opens.
3. Input the desired G-code commands using the operator's keyboard.
4. Press the <CYCLE START> key.
The control executes the input blocks.
Settings under program control
Settings under program control
Press the "Delete blocks" softkey.
The program displayed in the program window is deleted.
Setting up the machine
2.11 MDA
91