Siemens sinumerik 840D sl Operating Manual page 527

Parameter
Z3
Tool change
T
D
F4
X4
Z4
β5
γ5
Tracking
F6
X6
Z6
Y6
Turning
Operating Manual, 07/2010, 6FC5398-8CP40-0BA0
Description
3. position (inc or ∅ abs)
TlChngPt: Approach the tool change point from the last programmed position

and carry out a tool change
Direct: Tool is not changed at the tool change position, but at the last

programmed position
No: Tool is not changed

Tool name (not for tool change "no")
Cutting edge number (not for tool change "no")
Feedrate for approach to the fourth position
Alternatively, rapid traverse
4. position (inc or ∅ abs)
4. position (inc or ∅ abs)
Beta angle for 2nd swivel movement
Gamma angle for 2nd swivel movement
The position of the tool tip is maintained during swiveling.
Please refer to the machine manufacturer's instructions.
Feedrate to approach the sixth position
Alternatively, rapid traverse
6. position (inc or ∅ abs)
6. position (inc or ∅ abs)
Retraction to safety clearance
Working with a B axis
12.5 Approach/retraction
Unit
mm
mm/min
mm
mm
Degrees
Degrees
mm/min
mm
mm
mm
527