Siemens sinumerik 840D sl Operating Manual page 235

4. Input of finished part with contour computer
Turning
Operating Manual, 07/2010, 6FC5398-8CP40-0BA0
7. Press the "Accept" softkey.
It is only necessary to enter the blank contour when using a pre-
machined blank.
Blank contour
1. Press the "Cont. turn." and "New contour" softkeys.
The "New Contour" input window opens.
2. Enter the contour name (in this case: Cont_2).
The contour calculated as NC code is written as internal subprogram
between a start and an end marker containing the entered name.
3. Press the "Accept" softkey.
The "Starting point" entry field opens.
4. Specify the contour starting point of the contour.
X 0 abs
5. Press the "Accept" softkey.
Creating a ShopTurn program
7.18 Example: Standard machining
Z 0 abs
235