Teaching in a program
11.5 Editing a block
11.5
Editing a block
You can only overwrite a program block with a teach-in block of the same type.
The axis values displayed in the relevant window are actual values, not the values to be
overwritten in the block.
Note
If you wish to change any variable in a block in the program block window other than the
position and its parameters, then we recommend alphanumerical input.
Requirement
The program to be edited is selected.
Proceed as follows
514
1.
Select the "Machine" operating area.
2.
Press the <AUTO> or <MDA> key.
3.
Press the <TEACH IN> key.
4.
Press the "Teach prog." softkey.
5.
Click the program block to be edited.
6.
Press the relevant softkey "Teach position, "Rap. tra. G0", "Straight
line G1", or "Circ. interm. pos. CIP", and "Circ. end pos. CIP".
The relevant windows with the input fields are displayed.
7.
Traverse the axes to the desired position and press the "Accept"
softkey.
The program block is taught with the modified values.
- OR -
Press the "Cancel" softkey to cancel the changes.
Operating Manual, 07/2010, 6FC5398-8CP40-0BA0
Turning