Siemens sinumerik 840D sl Operating Manual page 573

Figure 13-18 Selection list for special tools with multitool
Procedure
Turning
Operating Manual, 07/2010, 6FC5398-8CP40-0BA0
1. The tool list is opened.
2. Position the cursor at the position where the tool is to be
created.
For this, you can select an empty magazine location or the NC
tool memory outside of the magazine.
You may also position the cursor on an existing tool in the area
of the NC tool memory. Data from the displayed tool will not be
overwritten.
3. Press the "New tool" softkey.
The "New Tool - Favorites" window opens.
- OR -
Press the "Special tool 700-900" softkey.
4. Select the multitool and press the "OK" softkey.
The "New tool" window appears.
Tool management
13.14 Working with multitool
573