Editing The Multi-Channel Program; Changing The Job List - Siemens sinumerik 840D sl Operating Manual

Multi-channel support
9.3 Multi-channel editor
Procedure
9.3.3

Editing the multi-channel program

9.3.3.1

Changing the job list

You now have the option to change the composition of the programs and/or the assignment
of the channel and program in a job list.
Precondition
● "programSYNC" option
Procedure
468
1. You have created programs for the multi-channel machining in
the job list and the parameter screen "multi-channel data" is
open in the editor.
2. Enter the data for the cross-channel data.
3. Press the "Accept" softkey.
The multi-channel editor is opened and displays the programs
that have been created.
The cursor is positioned on an empty line before the cycle for
the job list (CYCLE208). This means that you have the option to
enter initializations for the G code program that are immediately
required.
1. Select the "Program Manager" operating area.
2. Select where the multi-channel program should be archived
3. Position the cursor in the "Workpieces" folder on a job list and press
the "Open" softkey.
The window "Job list * JOB" is opened and the program assignment to
the channels is displayed.
4. Select the channel to which you wish to assign a new program and
press the softkey "Select program".
The "Program" window is opened and displays all of the programs
created in the workpiece.
Operating Manual, 07/2010, 6FC5398-8CP40-0BA0
Turning