Setting-Up Events - Siemens sinumerik 840D sl Operating Manual

Easy Message (828D only)

17.4 Setting-up events

17.4 Setting-up events
In the "Send SMS for the following events" area, select the events using the check box,
which when they occur, an SMS is sent to the user.
● Programmed messages from the part program (MSG)
● Select the following events using the <SELECT> key
● Messages/alarms from the Tool Manager
● Measuring cycle messages for tools
● Measuring cycle messages for workpieces
● Sinumerik messages/alarms (error when executing)
An SMS is sent if NCK alarms or messages are output that cause the machine to come to
a standstill.
● Machine faults
An SMS is sent if PLC alarms or messages are output that cause the machine to come to
● Maintenance intervals
● Additional alarm numbers:
640
In the part program, program an MSG command via which you receive an SMS.
Example: MSG ("SMS: An SMS from a part program")
– The workpiece counter reaches the following value
An SMS is sent if the workpiece counter reaches the set value.
– The following program progress is reached (percent)
An SMS is sent if, when executing a part program, the set progress is reached.
– Actual NC program reaches runtime (minutes)
An SMS is sent after the set runtime has been reached when executing an NC
program.
– Tool usage time reaches the following value (minutes)
An SMS is sent if the usage time of the tool reaches the set time when executing a
part program (derived from $AC_CUTTING_TIME).
An SMS is sent if messages or alarms are output to the Tool Manager.
An SMS is sent if measuring cycle messages are output that involve tools.
An SMS is sent if measuring cycle messages are output that involve workpieces.
a standstill (i.e. PLC alarms with Emergency Off response).
An SMS is sent if the service planner registers pending maintenance work.
Here, specify additional alarms where you should be notified if they occur.
You can enter individual alarms, several alarms or alarm number ranges.
Examples:
1234,400
1000-2000
100,200-300
Operating Manual, 07/2010, 6FC5398-8CP40-0BA0
Turning