Siemens sinumerik 840D sl Operating Manual page 578

Tool management
13.14 Working with multitool
Procedure
Reactivating and positioning
When the "Reactivate with positioning" function is configured, then also the magazine
location at which the selected multitool is located, is positioned to the loading point. You can
exchange the multitool.
Reactivation of all monitoring types
When the "Reactivation of all monitoring types" function is configured, all the monitoring
types set in the NC for a tool are reset during reactivation.
References
Commissioning Manual SINUMERIK Operate (IM9) / SINUMERIK 840D sl
578
1. Select the "Parameter" operating area.
2. Press the "Tool wear" softkey.
3. Position the cursor at the multitool that is disabled and which
you would like to reactivate.
- OR -
Position the cursor on the tool that you would like to reactivate
again.
4. Press the "Reactivate" softkey.
The value entered as the setpoint is entered as the new tool life
or workpiece count.
The tool and the multitool are then no longer disabled (the
disable is withdrawn).
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Operating Manual, 07/2010, 6FC5398-8CP40-0BA0
Turning