Siemens sinumerik 840D sl Operating Manual page 563

Several magazines
If you have set up several magazines, then the "...relocate from magazine... location... to..."
window appears after pressing the "Relocate" softkey.
Select the desired magazine and location, and confirm your selection with "OK" to load the
tool.
Turning
Operating Manual, 07/2010, 6FC5398-8CP40-0BA0
3. Press the "Relocate" softkey.
The "... relocate from location ... to location ..." window is displayed.
The "Location" field is pre-assigned with the number of the first empty
magazine location.
4. Press the "OK" softkey to relocate the tool to the recommended
magazine location.
- OR -
Enter the required magazine number in the "...magazine" field and the
required magazine location number in "Location" field.
Press the "OK" softkey.
The tool is relocated to the specified magazine location.
Tool management
13.8 Magazine
563