Creating A Protocol Template - TP-Link T1600G-18TS Configuration Manual

Configuring Protocol VLAN

2.2.2 Creating a Protocol Template

Follow these steps to create a protocol template:
Step 1
Step 2
Step 3
Step 4
Step 5
The following example shows how to create an IPv6 protocol template on T1600G-52TS:
Switch#configure
Switch(config)#protocol-vlan template name IPv6 frame ether_2 ether-type 86dd
Switch(config)#show protocol-vlan template
Index Protocol Name
------- -----------------
1 IP
configure
Enter global configuration mode.
For T1600G-18TS:
protocol-vlan template name protocol-name frame ether-type type
Create a protocol template.
Specify the protocol name with 1 to 8 characters.
protocol-name:
: Specify the Ethernet protocol type with 4 hexadecimal numbers. It ranges from 0600
type
to FFFF.
For other T1600G series switches:
protocol-vlan template name protocol-name frame { ether_2 ether-type type | snap ether-
type type | llc dsap dsap_type ssap ssap_type }
Create a protocol template.
Specify the protocol name with 1 to 8 characters.
protocol-name:
: Specify the Ethernet protocol type with 4 hexadecimal numbers. It ranges from 0600
type
to FFFF.
: Specify the destination service access point with 2 hexadecimal numbers.
dsap_type
: Specify the source service access point with 2 hexadecimal numbers.
ssap_type
show protocol-vlan template
Verify the protocol templates.
end
Return to Privileged EXEC Mode.
copy running-config startup-config
Save the settings in the configuration file.
Protocol Type
--------------------------------
EthernetII ether-type 0800
Protocol VLAN Configuration
Configuration Guide 185