Table of Contents
Advertisement
Configuring Protocol VLAN
802.1p Priority
2) Select the desired ports. Click Create.
Note:
The member port of an LAG (Link Aggregation Group) follows the configuration of the LAG and not
its own. The configurations of the port can take effect only after it leaves the LAG.
2.2
Using the CLI
2.2.1 Configuring 802.1Q VLAN
Before configuring protocol VLAN, create an 802.1Q VLAN and set the port type according
to network requirements. For details, refer to
2.2.2 Creating a Protocol Template
Follow these steps to create a protocol template:
Step 1
Step 2
Step 3
Step 4
Step 5
Specify the 802.1p priority for the packets that belong to the protocol VLAN. The
switch will determine the forwarding sequence according this value. The packets
with larger value of 802.1p priority have the higher priority.
configure
Enter global configuration mode.
protocol-vlan template name protocol-name frame { ether_2 ether-type type | snap ether-
type type | llc dsap dsap_type ssap ssap_type }
Create a protocol template.
Specify the protocol name with 1 to 8 characters.
protocol-name:
: Enter4 hexadecimal numbers as the Ethernet protocol type for the protocol template.
type
It is the Ether Type field in the frame and is used to identify the data type of the frame.
: Enter 2 hexadecimal numbers as the DSAP value for the protocol template. It is
dsap_type
the DSAP field in the frame and is used to identify the data type of the frame.
: Enter 2 hexadecimal numbers as the SSAP value for the protocol template. It is
ssap_type
the SSAP field in the frame and is used to identify the data type of the frame.
show protocol-vlan template
Verify the protocol templates.
end
Return to Privileged EXEC Mode.
copy running-config startup-config
Save the settings in the configuration file.
Configuring 802.1Q
VLAN.
Protocol VLAN Configuration
Configuration Guide
179
Advertisement
Table of Contents
