TP-Link T1600G-18TS Configuration Manual page 536

Configuring ACL
ACL ID
Rule ID
Operation
2) Configure the rule's packet-matching criteria.
S-MAC/Mask
D-MAC/Mask
3) Click Apply.
 Configuring the Standard-IP ACL Rule
Choose the menu ACL > ACL Config > Standard-IP ACL to load the following page.
Figure 2-3 Creating the Standard-IP ACL Rule
Follow these steps to create the Standard-IP ACL rule:
1) Select a Standard-IP ACL from the drop-down list, enter a Rule ID, and specify the
operation for the matched packets.
ACL ID
Rule ID
Select an MAC ACL from the drop-down list.
Specify the rule ID, which ranges from 0 to 999.
It should not be the same as any existing MAC ACL Rule IDs.
Select an operation to be performed when a packet matches the rule.
Permit: To forward the matched packets.
Deny: To discard the matched packets.
Enter the source MAC address with a mask. A value of 1 in the mask indicates
that the corresponding bit in the address will be matched.
Enter the destination IP address with a mask. A value of 1 in the mask
indicates that the corresponding bit in the address will be matched.
tandard-IP
Select a S ACL from the drop-down list.
Specify the rule ID, which ranges from 0 to 1999.
It should not be the same as any existing
ACL Configurations
Standard-IP
ACL Rule IDs.
Configuration Guide 513