Configuring Ipv6 Parameters Of The Interface - TP-Link T1600G-18TS Configuration Manual

Configuring Logical Interfaces
Interface
---------
Gi1/0/1
Switch(config-if)#end
Switch#copy running-config startup-config

2.2.3 Configuring IPv6 Parameters of the Interface

Follow these steps to configure the IPv6 parameters of the interface.
Step 1
Step 2
Step 3
Step 4
IP-Address
----------
192.168.0.100/24 Static
configure
Enter global configuration mode.
interface { interface-type } { interface-number }
Enter layer 3 interface configuration mode.
: Type of the layer 3 interface, including fastEthernet, gigabitEthernet,
interface-type
ten-gigabitEthernet, loopback and VLAN.
Number of the interface.
interface-number:
ipv6 enable
Enable the IPv6 function on the speicified Layer 3 interface. By default, it is enabled on
VLAN interface 1. IPv6 function can only be enabled on one Layer 3 interface at a time.
Configure the IPv6 link-local address for the specified interface:
Manually configure the ipv6 link-local address for the specified interface:
ipv6 address ipv6-addr link-local
ipv6-addr : Specify the link-local address of the interface. It should be a standardized IPv6
address with the prefix fe80::/10, otherwise this command will be invalid.
Automatically configure the ipv6 link-local address for the specified interface:
ipv6 address autoconfig
Method Status Protocol Shutdown
------ ------ --------
Up Up
Logical Interfaces Configurations
--------
no
Configuration Guide 386